- When the clutch started slipping, I looked for parts and saw the Advantage Reinforced Clutch Kit and ordered it.Replacement was not that difficult if the procedure was followed.The weight of Clutch, w...اقرأ أكثر
- All parts are provided in accordance with OEM manuals and product instructions.I have assembled it, but when I put it in 1st gear from Neutral.I had to reassemble it three times because it would stall...اقرأ أكثر
- OEM was vague (a little slippery) on Meet Point.This is a connection, but it is firm (Spring effect Large).اقرأ أكثر
- I think I felt it more because I replaced the clutch when it started slipping. It is easy to grasp the timing of the cornering and the acceleration, so I would highly recommend it.اقرأ أكثر
- I have not used it yet, but after researching a lot of information, I decided to Stock it, so I bought it.اقرأ أكثر
- [How is it used?I thought it was time to replace the OEM Clutch board.Buy this KitWas the one you received as per Image?The only difference is that Spring's color is Black.Was the installation difficu...اقرأ أكثر
- The clutch was a normal clutch that had been used for many years, but after 80,000km, it recently started slipping, so we decided to replace it with an Advantage FCC. Since it was a good opportunity, ...اقرأ أكثر
- It was OEM and a little slippery.When I switched to this one, they are tightly connected and do not slip at all.As one would expect from the FCC.Durability was not bad, and it did not seem to diminish...اقرأ أكثر
- I did the Bore up and used the OEM Clutch, and sure enough, it slipped & hellip; I could use it, but the Torque increased with the Bore up, and the Embrake became harder, so I changed to this one with...اقرأ أكثر
- * Measure the weight of the spring includedIt is 30Gram lighter than NORMAL* Length of SpringIt's a bit longer than NORMAL, but the hardness might not change.Is it corresponding to 3GM5 '91 because it...اقرأ أكثر
- I purchased this product to reduce embrittlement and friction loss.It's expensive, but it's really good.good pointEmbracing is calm. So you can concentrate only on cornering on the way down.● It also ...اقرأ أكثر
- After 20 years from new I finally had to change the clutch in my Honda CB750 RC42. Especially now that I run a Keihin CR31 carb and CBX750 RC17 camshafts it will need a good clutch with this increased...اقرأ أكثر
- The Clutch started to slip, so I installed it as a repair.Slippage was cured, but Clutch's weight was improved.My KATANA, coupled with YRP's Easy Clutch, is a finger Quantity:2pc will cut Clutch.اقرأ أكثر
- [First things first].For some reason, the 750S1/S2 Clutch is notorious for being heavier to pull than the 1100S.Even on a day touring, my left hand was a wreck on the way home, so it was serious enoug...اقرأ أكثر
- I've been suffering from the disease of not being able to blow the Engine for nearly two years.After two laps of electrical and mechanical review, we finally made it to the finish line.And it's in the...اقرأ أكثر
- I installed it on Racer's WR250X, the OEM Clutch slipped so I replaced it with this one. Intake/exhaust, ECU was rewritten and there was power, but it may be overspecifications for me because I don't ...اقرأ أكثر
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING